Relay module - Faller

Faller brand relay module Influence the scenarios according to the situation. Module made up of 2 relays (12 V DC) on a small card allowing various actions to be triggered on the model by plugging in bridges (also called jumpers). - Connected to the »Traffic control« Art. 161651 or to the »Extension module« Art. 161352 we can p. ex. start or stop a smoke generator Art. 180690 or a synchronous model motor Art. 180629 (alternating voltage) .- Connected to an »Extension module« it is possible with one of the outputs to operate a motor in forward gear by inserting the bridges appropriately, and with another output the same motor in reverse gear. This module also makes it possible to connect different potential-free digital systems: one of the systems will trigger the relay and this signal will be used in another system - By fitting the bridges in an appropriate way, two signals can be generated from one signal: given that we use respectively a breaker and a contactor of the relay, either contact will close depending on whether the relay closed or opened. By connecting the relay module accordingly, a signal can also be inverted - By inserting the relay module, higher currents or other voltages (e.g. AC voltage) can be used on modules whose outputs are too low for the desired current. Other possibilities of implementation are described in the supplied instructions for use. two signals can be generated from one signal: given that a breaker and a relay contactor are used respectively, one or the other contact will close depending on whether the relay has closed or opened . By connecting the relay module accordingly, a signal can also be inverted - By inserting the relay module, higher currents or other voltages (e.g. AC voltage) can be used on modules whose outputs are too low for the desired current. Other possibilities of implementation are described in the supplied instructions for use. two signals can be generated from one signal: given that a breaker and a relay contactor are used respectively, one or the other contact will close depending on whether the relay has closed or opened . By connecting the relay module accordingly, a signal can also be inverted - By inserting the relay module, higher currents or other voltages (e.g. AC voltage) can be used on modules whose outputs are too low for the desired current. Other possibilities of implementation are described in the supplied instructions for use. is closed or has opened. By connecting the relay module accordingly, a signal can also be inverted - By inserting the relay module, higher currents or other voltages (e.g. AC voltage) can be used on modules whose outputs are too low for the desired current. Other possibilities of implementation are described in the supplied instructions for use. is closed or has opened. By connecting the relay module accordingly, a signal can also be inverted - By inserting the relay module, higher currents or other voltages (e.g. AC voltage) can be used on modules whose outputs are too low for the desired current. Other possibilities of implementation are described in the supplied instructions for use.